Skip to document
Welcome to StudocuSign in to access the best study resources
Guest user
0followers
HomeMy LibraryAsk AI
  • You don't have any recent items yet.
My Library
  • You don't have any modules yet.
  • You don't have any books yet.
  • You don't have any Studylists yet.

Investigating Gas Laws

idktbh
Module

General and Organic Chemistry (AOC106DI)

26 Documents
Students shared 26 documents in this course
Academic year: 2016/2017
Listed bookCollins Spanish Dictionary
Uploaded by:
Student
Pedro Mariano
Coventry University
0followers
1Uploads
0upvotes

Comments

Please sign in or register to post comments.

Students also viewed

Related documents

Preview text

Boyle’s Law Method 1. With the plunger removed from the syringe, measure the inside diameter, d of the syringe using a vernier calliper. Take at least 3 repeat readings and find an average. 2. The plunger should be replaced and the rubber tubing should be fit over the nozzle and clamped with a pinch clip as close to the nozzle as possible. 3. Set up the apparatus as shown in the diagram and make sure the temperature of the room will remain constant throughout. 4. Push the syringe upwards until it reads the lowest volume of air visible. Record this volume. 5. Add the mass holder with a 100g mass on it to the loop of string at the bottom of the plunger. Wait a few seconds to ensure the temperature is kept constant since work is done against the plunger when the volume increases. 6. Record the value of the new volume from the syringe scale. 7. Repeat the experiment by adding two 100g masses at a time up to 8-10 readings. This is so a significant change in volume can be seen each time. 8. Record the mass and volume.

Was this document helpful?

Investigating Gas Laws

Module: General and Organic Chemistry (AOC106DI)

26 Documents
Students shared 26 documents in this course

University: Coventry University

Was this document helpful?
Boyle’s Law
Method
1. With the plunger removed from the syringe, measure the inside diameter, d of the
syringe using a vernier calliper. Take at least 3 repeat readings and find an average.
2. The plunger should be replaced and the rubber tubing should be fit over the nozzle and
clamped with a pinch clip as close to the nozzle as possible.
3. Set up the apparatus as shown in the diagram and make sure the temperature of the
room will remain constant throughout.
4. Push the syringe upwards until it reads the lowest volume of air visible. Record this
volume.
5. Add the mass holder with a 100g mass on it to the loop of string at the bottom of the
plunger. Wait a few seconds to ensure the temperature is kept constant since work is
done against the plunger when the volume increases.
6. Record the value of the new volume from the syringe scale.
7. Repeat the experiment by adding two 100g masses at a time up to 8-10 readings. This is
so a significant change in volume can be seen each time.
8. Record the mass and volume.

Students also viewed

Related documents